2009 dodge ram canmax400 rs
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122879
Printed Date: July 12, 2025 at 4:34 AM
Topic: 2009 dodge ram canmax400 rs
Posted By: pimpin_camry
Subject: 2009 dodge ram canmax400 rs
Date Posted: July 28, 2010 at 7:58 PM
Ok. So I told a buddy that I was doing this for him before i found out what it consisted of. I've been doing alarm systems for quite a few years but have never attempted one with the data/can system.
I have installed the python remote start with the docked canmax400 as shown in the diagram that came with the xpresskit. When powered up I get a solid red light and have seen 2 different meanings for this. Does anyone know for sure what this means?
I also installed the xkeychgm. Does this program before or after the canmax?
I am getting an error message when trying to flash the canmax400 and not getting any further than this.
Any help would be appreciated.
Replies:
Posted By: pimpin_camry
Date Posted: July 28, 2010 at 7:59 PM
Sorry, the above is for a 2009 Dodge Ram with the wireless ignition node. No factory keyless
Posted By: kgerry
Date Posted: July 29, 2010 at 10:26 AM
did you flash the canmax with the correct firmware??
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
|