remote start failue

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=122992
Printed Date: April 20, 2024 at 4:05 AM

Topic: remote start failue

Posted By: cs310i
Subject: remote start failue
Date Posted: August 06, 2010 at 8:39 AM

2002 Honda Accord SE sedan Command Start CS310i
After reconnecting the car battery the remote start feature no longer works. The engine turns over but does not start. All other functions of the command start work. Is there something that must be reset? Thanks.

Replies:

Posted By: howie ll
Date Posted: August 06, 2010 at 10:25 AM

Have you tested the alarm, supply voltage? Grounds, connections, fuses? Maybe it was power and grounded from the battery and these connections have't been replaced.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: supadave01
Date Posted: August 06, 2010 at 12:19 PM

CHECK TO SEE IF IN MANUAL TRANS MODE.ALSO CHECK YOUR NEUTRAL SAFETY SWITCH

-------------
all work no play all day

Posted By: cs310i
Date Posted: August 09, 2010 at 9:46 AM

The reset instructions in this manual are not right for the bypass module that I have, because there's no reset button to press and hold. Instead, there's 4 jumper pins as shown on IMG_5066
Is there a certain way that I need to put the jumper across these pins to do a reset?
Thanks.

Print Page | Close Window