cobalt remote start
Printed From: the12volt.comForum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=123030
Printed Date: May 12, 2025 at 1:55 PM
Topic: cobalt remote start
Posted By: mpjayden
Subject: cobalt remote start
Date Posted: August 08, 2010 at 4:31 PM
I have a 2006 chevy cobalt and trying to install an AutoStart remote start system. I have the xpresskit bypass module and which doesnt require a key. I click on the start button and nothing happens but the horn will honk a couple times 
the only thing I think it could be is the ignition wire or accessory/blower wire. But I put a multimeter to the ignition wire and pressed the start button and no voltage was read through that wire (Both accessory/blower and ignition wire are connected at bcm, not ignition if that could make a difference?). Could the remote start module just be bad? This is puzzeling me. The starter wire is not connected because I read that it doesn't need to be wired for the cobalts.
the only thing I think it could be is the ignition wire or accessory/blower wire. But I put a multimeter to the ignition wire and pressed the start button and no voltage was read through that wire (Both accessory/blower and ignition wire are connected at bcm, not ignition if that could make a difference?). Could the remote start module just be bad? This is puzzeling me. The starter wire is not connected because I read that it doesn't need to be wired for the cobalts. -------------
Mike
Replies:
Posted By: abethebue
Date Posted: August 08, 2010 at 5:03 PM
Posted By: beegbie
Date Posted: August 08, 2010 at 5:03 PM
Posted By: icearrow6
Date Posted: August 08, 2010 at 5:22 PM
Posted By: mpjayden
Date Posted: August 08, 2010 at 6:58 PM