05 acura rsx, viper 5901

I'm installing a pkh34 in my 05 Acura RSX. witch install should I use? type A or B? Thanks in advance!

Hello does anyone know how wire a 530t window unit to roll up the windows when the warn away is tripped. Or how to use a 508d proximity sensor to roll them up if some one gets to close? Thanks!

Some times I like to leave them down if I'm just running in to the gas station or some ware for just a sec.

2005 Acura RSX with PKH34 is Install Type A.  Here is a link to the DEI site for the install guide download for the diagram and wire colors:  https://www.xpresskit.com/product.aspx?productid=212

-------------
Soldering is fun!

I just installed a viper 5901 in my 05 Acura rsx type s. when I go in to Programming System Features I fallow the directions as fallows.
Programming System Features
The System Features Learn Routine dictates how the unit operates. It is possible to access and change most of
the feature settings using the Control button.
1. Open a door.
2. Turn the ignition on, then off.
3. Select a Menu. Press and hold the Control button. The number of siren chirps indicates the menu number.
1 chirp indicates menu 1, 2 chirps - menu 2 and 3 chirps for menu 3.
4. When the desired menu chirps are heard, release the Control button.
5. Select a Feature. Press and release the Control button the number of times corresponding to the feature
you wish to change. Then press and hold one more time to select the features.
6. Program the Feature. While holding the Control button, you can program the feature using the remote
control.
For features with only two options lock = option 1 while unlock = option 2.
For features with more than two options lock selects the options in ascending order, while unlock selects them in
descending order.

The problem I'm running in to is in the last step. When I hold the control button down and try to toggle with the remote it does not seam to work right. The remote doesn't do any thing and the siren just keeps going through a series of beeps 1 then 2 then 3 as long as I keep holding it down.

I'm trying to program it for Tachometer witch is Menu 3 , Menu item 2, Opt.4.
Thanks for any help in advance!

I just did this over the weekend with my toyota. When you press the lock button, it'll cycle through the options, 1 beep for option 1, 2 beeps for options 2, etc.

I have installed a viper 5901 in a 05 Acura RSX type s. I have read the install book over and over and everything seams right. I have the tach hooked to the violet/ white wire. I got the signal at the ecu it shows 0-7 volts. I went in to the menu 3 settings and set Engine Checking Mode to Opt.4 for Tachometer. For some reason it will not learn? Thanks for any help in advance!!

Audiovox and Bulldog suggest using the Tach Test wire.  Might be worth a try.

TACH   BLUE         @ TACH TEST CONNECTOR        THE TACH TEST CONNECTOR IS BEHIND THE DRIVERS SIDE HEADLIGHT.

Tachometer             BLUE/SILVER DOTS  (AC)              SINGLE PIN TACH TEST CONN.

THE TACH TEST CONNECTOR IS LOCATED NEAR THE BATTERY TAPED TO A HARNESS.
CAN ALSO USE ANY INJECTOR WIRE THAT IS NOT YELLOW/BLACK. ENGINE COVER MUST BE REMOVED TO ACCESS THE INJECTORS. 

-------------
Soldering is fun!