Print Page | Close Window

manual door locks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=123232
Printed Date: April 27, 2024 at 11:37 AM


Topic: manual door locks

Posted By: ianarian
Subject: manual door locks
Date Posted: August 24, 2010 at 2:12 PM

Sup fellas, I got a 350 plus most of the way installed in my 08 Frontier. I want to set up the alarm to go off only when the doors open. I was good to go until I thought about forgetting to turn off the alarm prior to manually unlocking the doors. My truck is manual everything, windows, locks, tranny..etc. That being the case, do I have any options to disengage the alarm while manually unlocking the doors with a key? Either way, to achieve my goal, which circuit is the most ideal to use to engage the alarm upon door opening? I was thinking of tapping into the circuit running the dome light, being it is that it energizes when either door is opened.



Replies:

Posted By: i am an idiot
Date Posted: August 24, 2010 at 7:43 PM
WIRE COLOR POLARITY LOCATION posted_image
posted_image Battery GREEN (+) IGNITION SWITCH HARNESS
posted_image Ignition 1 WHITE/ GREEN (+) IGNITION SWITCH HARNESS
posted_image Starter 1 GRAY (+) IGNITION SWITCH HARNESS
posted_image All Door Trigger BROWN (-) AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR posted_image
posted_image Domelight Super BROWN (-) AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR
posted_image LF Latch GRAY (-) AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR
posted_image RF Latch LIGHT GREEN (-) AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR
posted_image LR Latch PINK (-) AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR
posted_image RR Latch BLUE (-) AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR
posted_image Alarm Disarm GRAY (-) AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR
posted_image Alarm Arm LIGHT BLUE (-) AT BCM MODULE BEHIND DRIVERS SIDE OF DASH ABOVE PEDALS BEHIND DIAGNOSTIC CONNECTOR
posted_image Parking Lights GRAY (+) IN HARNESS IN DRIVER KICKPANEL

Note for all door trigger reads: TO AVOID DOMELIGHT DELAY USE INDIVIDUAL DOOR TRIGGERS AND DIODE ISOLATE EACH WIRE





Posted By: ianarian
Date Posted: August 24, 2010 at 10:01 PM
Thanx Non-idi

-------------
This is what I do for FUN!




Posted By: ianarian
Date Posted: September 02, 2010 at 9:54 PM
Allriighty then....I get about a 1/2 hr a night with a flashlight to work on this. I am positive about every move made so far and may have a very stupid question. The 350 plus install guide notes read: "Never interrupt any wire other than the starter wire".. I presume that means it is the only wire that has to be cut and spliced into in series. In which case the two corresponding leads of the relay hook to each cut end of the starter wire... Starter interrupted, now the circuit reconnects through the relay. Which is controlled by the control center. Right or wrong...?

-------------
This is what I do for FUN!




Posted By: howie ll
Date Posted: September 03, 2010 at 1:41 AM
Yes.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.




Posted By: ianarian
Date Posted: September 03, 2010 at 1:41 PM
YeS!!!   Thanks,   Armed!

-------------
This is what I do for FUN!





Print Page | Close Window