how do i find out the number for each pin? i am try to install remote starter ( viper 5902) and I need to know which one is pin number 1 or number 2.....etc.
I am trying to install viper 5902 remote starter for honda civic 09. The harness 3 (10-pin connector), Pink (+) Ignition 1 input/output connects to Blue.
According to 12 volts wiring diagram honda civic 09 , this car has only one Ignition so where should i connect the Pink/White (+) Ignition 2 ?
how do i connect the PHK34 bypass to the viper? on the viper there are two D2D jumpers and D2D port (which has 4pin for each connector), which one should I use? D2D jumpers or D2D port.
I have never been using the by pass before, I really need help and I greatly appreciate the assistance.
How do i find out the number for each pin for the 42pin harness connector of honda civic 2009? I have no ideal which one is pin number 1 or number 2.....etc.
I greatly appreciate the assistance.
That vehicle has a second accesory wire use the pink/white on that.
As for the PKH34.
Download the install guide at https://www.xpresskit.com/product.aspx?productid=212 Follow the guide for Install B, Type "D". Set the Viper D2D jumpers to external module and connect the 4 pin cable between the modules. The only wire you will run from the PKH34 is the sloid Violet wire to the Civics Light Green wire at the ingition switch immobilizer connector, pin 3. It's a very thin wire and the connection should be soldered.
Don't worry too much about the pin numbers at the 42 pin connector. Go by wire color. Locate the wire and verify function with a DMM.
Make sure you change the Viper program option setting for H3/7 Pink/White heavy gauge wire to ACC2. As T&T mentioned above, you will be using it for the Civics' second accessory wire.
-------------
Soldering is fun!