Print Page | Close Window

python 460 for 03 maxima

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=123469
Printed Date: May 11, 2024 at 10:43 AM


Topic: python 460 for 03 maxima

Posted By: k1ll3r7
Subject: python 460 for 03 maxima
Date Posted: September 11, 2010 at 10:20 PM

I need help installing my python 460 in my o3 nissan maxima. i went to www.directed.com to try and find a guide but couldnt. someone please help me!



Replies:

Posted By: jcs091570
Date Posted: September 12, 2010 at 1:19 AM
This should be a pretty basic install...just depends what you want to hook up in addition.

Main wire Harness of alarm and connections to your vehicle wiring should be as follows... but double check your wire colors and use a volt meter if necessary to be sure.

Main Harness/Vehicle Wire

Red to Green of ignition harness..or constant 12v wire/battery
Brown to Red of Siren wire
Yellow to BLACK/ Red +Ignition wire
Black to Chassis ground..also ground black siren wire here if possible
Blue to Hood pin wire Yellow/Red (-) located at SECU optional
or can connect to Truck Pin Yellow/Red (-) optional

Green (-) door trigger to: door Trigger Wire (-): Find lt. green for the drivers door in pin 1, RED / blue for the passenger front door in pin 2, and RED / white for the rear doors in pin 3. Use all 3 wires and diode isolate each.
Door Trigger Wire Location: keyless entry module

White to: Parking Lights Positive Wire (+): RED / Blue
Parking Lights Positive Wire Location: Drivers Kick Panel




Posted By: jcs091570
Date Posted: September 12, 2010 at 1:30 AM
Part 2:
Orange to Orange of pre-wired starter kill relay.

I need to correct something in previous post... the Yellow from alarm harness will go to yellow of starter kill relay..there will be another yellow wire branching out of the relay that will connect to +ignition harness wire BLACK/ Red (smaller gauge).. sorry bout that

The green from starter kill relay goes to key side of starter wire BLACK/ red or BLACK/ white. This will be a thicker/bigger wire. Don't get it confused with the 12v ignition wire that is also BLACK/ red and is smaller gauge.

The black wire of the starter kill relay will go to the motor side of the starter wire which is either BLACK/ red or BLACK/ white (thicker wire)

Door Lock wire (green)from alarm to Door Lock Wire (-): ORANGE / black
Door Lock Wire Location: driver door module

Door unlock (blue) to Door Unlock Wire (-): ORANGE / blue
Door Unlock Wire Location: driver door module

***The SECU (Smart Entrance Control Unit) is located to the passengers side of the steering column.

Hope this helps for starters




Posted By: t&t tech
Date Posted: September 13, 2010 at 5:31 PM
Nope. If i remember correctly All harnesses except the power locking part come all black. N,B. If i remember correctly.





Print Page | Close Window