Print Page | Close Window

Pt cruiser 2001

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=12352
Printed Date: May 15, 2025 at 5:24 AM


Topic: Pt cruiser 2001

Posted By: superman1218
Subject: Pt cruiser 2001
Date Posted: April 17, 2003 at 9:09 PM

Whats up Guys,

  Im trying to install an Auto Page Alarm on my  2001 Chrysler Pt Cruiser.. I was wondering if anyone has a wiring diagram for this car. Thanks in advanced.



-------------
superman



Replies:

Posted By: diabloed
Date Posted: April 17, 2003 at 10:39 PM
12volts pink/black & red    +   ignition harness

Starter yellow    +   ignition harness

Ignition blue    +   ignition harness

Accessory BLACK/ orange    +   ignition harness

Second Accessory BLACK/ white    +   ignition harness

Power Lock WHITE/ green   -   drivers door harness
Notes: Locks are negative trigger through resistors. Must use relays. Use 3K (3000) ohms for lock/arm and 7.2K (7200) ohms for unlock/disarm. Unlock requires a double pulse.
Also found at the keyless entry module. The keyless module is located above the radio in the center of the dash.

Power Unlock same wire       

Parking Lights+ BLACK / YELLOW      drivers kick panel
Notes: Also found at the headlight switch.

Door Trigger      -     
Notes: The tan or tan/blu wire catches the drivers door and is found in the drivers kick panel. The blue/orange catches the three passenger doors and is found in the passengers kick panel. Use both wires and diode isolate each. Both wires are also found at the keyless module.

Dome Supervision use door trigger       

Trunk/Hatch Pin tan/black    -   drivers kick panel
Notes: Located in a 26 pin connector. Also found at the keyless module.

Hood Pin BROWN / tan    -   hood switch or
Notes: Also found at the keyless entry module. The keyless module is located above the radio in the center of the dash.

Tachometer BLACK/ gray      ignition coil

Brake Wire WHITE/ tan    +   brake switch

Horn Trigger BLACK/ red    -   steering column

Immobilizer By Pass : Chrysler vehicles that use a gray ignition key have an immobilizer system that needs to be bypassed when remote starting. Use DEI part number 555C or 555U. Locks are negative trigger through resistors. Must use relays. Use 3K (3000) ohms for lock/arm and 7.2K (7200) ohms for unlock/disarm. Unlock requires a double pulse.





Print Page | Close Window