clifford 50.7x doesn’t arm with rs
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=123661
Printed Date: May 11, 2025 at 2:07 AM
Topic: clifford 50.7x doesn’t arm with rs
Posted By: we87
Subject: clifford 50.7x doesn’t arm with rs
Date Posted: September 24, 2010 at 9:43 PM
I just got a Clifford 50.7x put in a 2002 Trailblazer and everything works fine except when you remote start the car- it bypasses the sensors. For example after the car gets remote started, I can open the doors and the alarm never gets triggered amd doesn't go off.
Any ideas?
Replies:
Posted By: howie ll
Date Posted: September 25, 2010 at 7:39 AM
You should take this up with the installers! By-passing the sensors should only happen whilst it's starting.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: we87
Date Posted: September 25, 2010 at 2:22 PM
....I am the installer :)
Posted By: howie ll
Date Posted: September 25, 2010 at 4:37 PM
You should have said "I put a Clifford in" rather than "I just got a Clifford put in".
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: we87
Date Posted: September 25, 2010 at 4:51 PM
OKay, thanks for the grammer tip. Any idea on the Clifford?
Posted By: howie ll
Date Posted: September 25, 2010 at 6:14 PM
Does this also happen when you simply set the alarm?
And was your alarm install to the standard of your grammar?
Is door open showing on your remote?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: we87
Date Posted: September 26, 2010 at 12:01 AM
No it doesn't happen when I arm the alarm normally. And yes it does show up on the remote.
Posted By: howie ll
Date Posted: September 26, 2010 at 3:38 AM
There is an override during remote start, but this should only be for the outside sensors such as prox, tilt etc.
As you said the doors shouldn't be affected.
I briefly looked over the installation guides (Directechs have three updates!) I originally thought it might be a programming error but I can't see it if your remote signals open door and opening a door triggers the alarm in normal mode when set.
It might be worthwhile to run a Bitwriter over the install.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: howie ll
Date Posted: September 26, 2010 at 5:10 AM
2 thoughts, read page 22 of the owner's manual; your are using the R/S when the alarm is on aren't you?
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: we87
Date Posted: September 26, 2010 at 3:06 PM
What are you referring to on page 22?
And yes, with the car armed- turning remote start on- the door triggers get bypassed ONLY after 15 seconds, during the initial 15 seconds the alarm gets triggered and goes off like it should with remote start on.
Posted By: howie ll
Date Posted: September 26, 2010 at 4:53 PM
Can't remember! Something about instant trigger, I suggest if no one else comes up with anything you contact DEI.
That 15 seconds worries me, it should be the other way round!
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|