v479 viper remote

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=123707
Printed Date: May 12, 2025 at 5:24 AM

Topic: v479 viper remote

Posted By: reed857
Subject: v479 viper remote
Date Posted: September 28, 2010 at 10:30 PM

remote stopped working.

took it apart and saw that there are two circutboards connected twice. one of the connections had worn solder points. thought that I would fix it instead of spend 100 for new remote.

remote now works, but is not receiving a signal back. the alarm and remote start work, but the remote is acting like I am out of range.

I am looking for some info on the layout of the chip to see if I over connected some things, and or any other helpful advice. thanks in advance.

Replies:

Posted By: Mark Mizenko
Date Posted: September 29, 2010 at 10:33 PM

You probably still have a bad joint.

I've fixed MANY of those remotes, the top one has 3 legs, and the lower connector has about 6 (8?).

If theres any of the tan glue on the connectors, use an Xacto knife blade to LIFT it off.

Use a SMALL tipped iron, and reflow all the joints.

Print Page | Close Window