ford flex factory alarm disarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=123780
Printed Date: May 02, 2024 at 5:57 PM
Topic: ford flex factory alarm disarm
Posted By: samh_08
Subject: ford flex factory alarm disarm
Date Posted: October 04, 2010 at 6:13 PM
I just did a 2010 Ford Flex the other night and the factory alarm disarm wire did not test right. Neither the Blue/brown or GREEN/ purple from the door harness drop to 0 while turning the key in the drivers door. I does have a factory alarm and also has a keyless entry keypad on the door.
What is even more weird is the fact that turning the key in the door doesn't disarm the alarm...
Any ideas?
Replies:
Posted By: Ween
Date Posted: October 04, 2010 at 8:42 PM
hi,
the factory alarm won't disarm with the key in the door.
it disarms with 1. pressing Unlock on a programmed remote/key, 2. using a programmed key cycled to RUN position, or 3. entering correct unlock code on door keypad. info obtained from Ford.
mark
Posted By: samh_08
Date Posted: October 04, 2010 at 9:16 PM
So how does one bypass the alarm for aftermarket remote starts? I have found that the remote start does bypass the alarm because it starts the vehicle, but I cannot get it to disarm with the aftermarket unlocking.
Posted By: Ween
Date Posted: October 05, 2010 at 6:14 AM
disarm by method two...trigger bypass module and ignition input, can't determine if special timing is required. diode isolate the bypass ground while running input and extra ignition output relay connected to the remote start disarm output.
|