trouble with tt and alarm
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=123855
Printed Date: November 04, 2025 at 7:06 AM
Topic: trouble with tt and alarm
Posted By: hvaltierra81
Subject: trouble with tt and alarm
Date Posted: October 10, 2010 at 2:42 AM
I just recently installed an apexi turbo timer to my 89 rx7. the car has an autopage rf225a alarm system. I didn't install the alarm it came with the car. when i installed the turbo timer i tapped into the ground wire and o2 sensor wire directly at the ecu. I didn't have the wire harness for the power wires so i tapped directly into the constant 12v, switch 1(labeled acc) and switch 2(labeled ign1) right at the ignition. now i cant arm my alarm if the turbo timer is counting down.as soon as the car shuts off i can arm it. My question is how can i arm the alarm system with the car still on and the turbo timer counting down.
thanks
Replies:
Posted By: howie ll
Date Posted: October 10, 2010 at 5:30 AM
See the other post on this topic.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: howie ll
Date Posted: October 10, 2010 at 6:05 AM
You will need 1 standard 5 pin automotive (Bosch type) relay and 1 X 1N4004 diode.
Ignition output from t/timer to 86.
Join the diode from 86 to 87a with the band to 86.
Ign wire, key side also to 87a
12V+ Constant,, fused at 30amps to 87
Ignition side of cut wire to 30.
Ground to 85.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: hvaltierra81
Date Posted: October 11, 2010 at 3:29 AM
ok i think i got it. the only issue im having is which ignition wire your talking about. the turbo timer and the ignition harness have 2 one gets power when the key is switched once and the other gets power when the key is switched a second time. so acc and on positions.
Posted By: howie ll
Date Posted: October 11, 2010 at 6:06 AM
On position, also take turbo timer from there as well, NOT acc.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|