dodge ram 2008

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=123885
Printed Date: May 20, 2024 at 9:36 AM

Topic: dodge ram 2008

Posted By: adamski
Subject: dodge ram 2008
Date Posted: October 11, 2010 at 9:42 PM

Hello I am in the middle of installation on viper 5902
I'm looking for wiring diagram for 2008 dodge ram that will tell me where to find door triggers, thank you any help I will really appreciate
Aja.

-------------
Adam

Replies:

Posted By: i am an idiot
Date Posted: October 11, 2010 at 10:47 PM

1500, 2500, or 3500? 2 dr. or 4 dr?

Posted By: adamski
Date Posted: October 12, 2010 at 7:02 AM

it's 2008 dodge ram 4 door 1500 hemi

-------------
Adam

Posted By: kreg357
Date Posted: October 12, 2010 at 7:30 AM

This info from Bulldog Security:

THE LEFT FRONT DOOR IS PURPLE IN PIN 1. THE RIGHT FRONT DOOR IS PURPLE / WHITE IN PIN 4. THE LEFT REAR DOOR IS PURPLE / ORANGE OR PURPLE /GRAY IN PIN 2. THE Right REAR DOOR IS PURPLE / YELLOW OR TAN / YELLOW IN PIN 3. USE ALL
4 WIRES AND DIODE ISOLATE EACH WIRE FROM EACH OTHER AND THE INSTRUMENT CLUSTER.

This info from Audiovox:

LF Latch   VIOLET (-)                  IN HARNESS IN DRIVERS KICKPANEL
RF Latch   VIOLET/WHITE (-)    IN HARNESS IN PASSENGER KICKPANEL
LR Latch   VIOLET/GRAY (-)      IN HARNESS IN DRIVER KCIKPANEL
RR Latch   VIOLET / YELLOW (-) IN HARNESS IN PASSENGER KICKPANEL

-------------
Soldering is fun!

Posted By: adamski
Date Posted: October 19, 2010 at 6:36 PM

viper 5902 Dodge ram 08 4 door installation

Hello I need some help, I got all wires done you can say, accept parking lights wire witch I run through 1120ohm resistor witch is giving me negative, do I need to use relay to switch the wire to positive, if I do what's the right way to wire the relay, if there is different easier way to go through??
thank you.

-------------
Adam

Posted By: kreg357
Date Posted: October 19, 2010 at 7:20 PM

This note from AudioVox : MUST ISOLATE FROM THE SWITCH WITH A RELAY DUE TO A REST RESISTANCE FORM THE SWITCH, USE A 1.1K OHM RESISTOR

Set your Viper Parking Light jumper to (+)

Use 30/40A SPDT relay

Viper H1/11 to Relay Pin 86

Relay Pin 85 to Chassis ground

Relay pin 87a to Light Switch side of cut WHITE/ Light Green wire

Relay Pin 87 thru 1.1 K Ohm resistor to chassis ground

Relay Pin 30 to car side of cut WHITE/ Light Green wire

-------------
Soldering is fun!

Posted By: adamski
Date Posted: October 26, 2010 at 8:47 PM

viper 5902, just finished installation. Thank you very much for all your help, does anyone of you know where I would be able to find defrost mirrors wire in 08 ram hemi 1500 4 door.
Thanks again.

-------------
Adam