could someone post a tech sheet for the 2008 VW Eos.
Thanks,
Here is info from Bulldog Security:
VOLKSWAGEN
MODEL YEAR(S)
EOS 2007 -2008
KEY T-HARNESS IMMOBILIZER
N/A N/A VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1
PART COLOR LOCATION
12 VOLT CONSTANT RED (+), 50 AMP @ FUSE BOX, (PIN 38), NOTE #2
STARTER RED / BLACK (+) @ VESCM, (12-PIN PLUG(G), PIN 1, NOTE #3
STARTER 2 N/A
IGNITION 1 BLACK (+) @ VESCM, (12-PIN PLUG(G), PIN 11, NOTE #3
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY /HEATER BLOWER 1 N/A
ACCESSORY /HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) GRAY / YELLOW (+) @ HEADLIGHT SWITCH or VESCM, (16-PIN PLUG(E), PIN 1, NOTE #3
POWER LOCK BROWN / GREEN (-), NOTE #4, See DIAGRAM @ DDCM, (20-PIN PLUG), PIN 32, NOTE #5
POWER UNLOCK Use LOCK wire, (-) thru a 250 Ohm Resistor to UNLOCK
DOOR TRIGGER BROWN / YELLOW (-) @ DDCM, (20-PIN PLUG), PIN 7, NOTE #5
DOMELIGHT SUPERVISION RED / PURPLE (-) @ VESCM, (12-PIN PLUG(B), PIN 11, NOTE #3
TRUNK RELEASE PURPLE (-) @ CSCCM, (8-PIN PLUG), PIN 6, NOTE #6
SLIDING POWER DOOR N/A
HORN BLACK/ WHITE (+) @ VESCM, (16-PIN PLUG(J), PIN 6, NOTE #3
TACH NOTE #7 @ Any FUEL-INJECTOR
WAIT TO START LIGHT N/A
BRAKE BLACK/ RED (+) @ BRAKE PEDAL SWITCH or VESCM, (16-PIN PLUG(E), PIN 2, NOTE #3
FACTORY ALARM DISARM NOTE #8 @ DDCM, (20-PIN PLUG), PIN 16, NOTE #5
ANTI-THEFT VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1 @ IGNITION SWITCH TUMBLER
EXTRA INFORMATION
NOTE #1: VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, Part # 791 Bypass Module, for REMOTE STARTING ONLY! Part # DLPK-CANBUS MULTI for REMOTE STARTING and DOOR LOCKS (Resistors for DOOR LOCKS, NOT REQUIRED)
NOTE #2: the FUSE BOX is located at the LEFT END of th DRIVERS DASH.
NOTE #3: the VESCM, (Vehicle Electrical System Control Module) is the RELAY BOX, Under the DRIVERS DASH.
NOTE #4: this vehicle uses a 1-WIRE DOOR LOCKING SYSTEM, that Requires Extra Parts for operation. See DIAGRAM. The use of Bypass Module DLPK-CANBUS MULTI will do the ANTI-THEFT and DOOR LOCKS without the use of relays and resistors.
NOTE #5: the DDCM, (Drivers Door Control Module) is located in the DRIVERS DOOR.
NOTE #6: the CSCCM, ( Comfort System Central Control Module) is located behind the GLOVE BOX.
NOTE #7: when using the TACH wire, use any wire NOT with a RED STRIPE(2.0T Engine) or a RED / BLACK(3.2 Engine) both test (AC)
NOTE #8: to DISARM FACTORY ALARM (if needed) Requires a (-) thru a 250 Ohm Resistor on the GREEN / WHITE (-) wire, requires resistor and relay. TEST this wire while turning the KEY in the DRIVERS DOOR.
Audiovox has it also : https://techservices.audiovox.com/Login.aspx Sign up is free.
-------------
Soldering is fun!