viper 5301 and dlpkgm tach wire and gwr?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124058
Printed Date: October 31, 2025 at 6:33 AM
Topic: viper 5301 and dlpkgm tach wire and gwr?
Posted By: vtvette
Subject: viper 5301 and dlpkgm tach wire and gwr?
Date Posted: October 21, 2010 at 10:16 PM
Hello, I've been installing a Viper 5301/DLPKGM in my '04 Chevy Avalanche. With the help of the search function on this forum I'm pretty confident I'm hooked up correctly.
My only two concerns are:
Tach Wire: I'm seeing conflicting info on this - should I hook the tach input on the RS IN connector on the Viper to the Violet/White Tach wire on the DLPKGM or, do I splice the Viper's tach wire into the tach wire in the truck's harness?
On the DLPKGM - the Ground While Running status wire ((blue/white) - I cannot figure out which wire on the Viper to hook this to? I see Ground When Armed on Viper Connector H1/12 (Orange) but, I've learned through searching here that this is not the same as Ground When Running.
Help with these two wires would be greatly appreciated thanks!
Replies:
Posted By: cvsct698
Date Posted: October 21, 2010 at 10:24 PM
1) Connect to the violet/white on the DLPKGM.
2) Viper calls it Status output. There should be a couple of them, one will be a small gauge blue wire, the other a small gauge blue and white wire.
Posted By: cvsct698
Date Posted: October 21, 2010 at 10:30 PM
Oh yeah, for Status Output, you only need to connect to one of them.
|