door lock 5902 in ’02 ram
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124109
Printed Date: May 15, 2024 at 9:21 AM
Topic: door lock 5902 in ’02 ram
Posted By: lins
Subject: door lock 5902 in ’02 ram
Date Posted: October 24, 2010 at 5:26 PM
I know this is a basic question, but I can't get the door locks figured out. Everything else is done. Are the door locks single or double pulse? I have actually tried both, but just can't get it to work.
I removed a Command Start CS-310i, so I tried just wiring the 5902 into the relays already installed but it won't work. They were running two relays running into the one WHITE/ green wire as mentioned in all the wiring diagrams. I have not checked what if any resistors are installed yet.
Thanks much in advance!
Replies:
Posted By: i am an idiot
Date Posted: October 24, 2010 at 5:37 PM
If the door locks were working with the other alarm, the resistors must be there.
 |
Power Unlock |
|
WHITE/ GREEN |
|
(-) |
|
DR. KICK PANEL USE 320 OHM RESISTOR |
|
|
|
PowerLock |
|
WHITE/ GREEN |
|
(-) |
|
DR. KICK USE 680 OR 815 OHM RESISTOR |
Posted By: lins
Date Posted: October 24, 2010 at 5:46 PM
That's what I was thinking, but it won't work, even with swapping wires. Guess I'll try checking the resistance or the relay wiring. Is there any point to the relays or can I just diode isolate? Cheers in advance.
Posted By: howie ll
Date Posted: October 24, 2010 at 5:54 PM
You definitely need relays with the 59XX series. I've done an 04 Ram, (probably about 10 in the UK) and I had to use double pulse lock and unlock. Just ground each lead first to see if the locks work.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: howie ll
Date Posted: October 24, 2010 at 5:56 PM
On those relays, signal from alarm to 85, 12Volt+ constant, fused 1amp to 86, ground to 87 and output via the resistor from 30.
What would diode isolation achieve, the end result is a ONE wire multiplex.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: lins
Date Posted: October 24, 2010 at 7:06 PM
Works great, thanks! Single pulse works perfect on my '02.
|