Print Page | Close Window

clutch bypass

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124125
Printed Date: May 06, 2025 at 8:00 PM


Topic: clutch bypass

Posted By: lapolvora
Subject: clutch bypass
Date Posted: October 25, 2010 at 7:22 PM

Anyone know how to bypass the clutch for a 2008 ford fusion?? i read 5v on the switch.

  im installing  a prostart CT-3271.

thanks in advance

Eri




Replies:

Posted By: Velocity Motors
Date Posted: October 25, 2010 at 8:11 PM
There are two switches for the clutch. Did you grab the right one to meter ?

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA



Posted By: lapolvora
Date Posted: October 26, 2010 at 5:13 PM

yes i did,  push switch engine start ,

 i read + 5 v on meter, clutch not pressed, clutch pressed reads 0 V, main switch on (engine off).

 the other is cruise control switch.




Posted By: Ween
Date Posted: October 26, 2010 at 7:14 PM
hi,
blue/orange (neg) ...receives ground when pedal is depressed fully.
configure the jumper at back of module to starter 2 to allow green wire (on main power connector) to be a second starter wire. have that trigger a relay to supply a ground to blue orange. relay connections... term 86 (green, 2nd start), term 85 & term 30 (ground), term 87 (blue/orange, clutch position switch)



Posted By: lapolvora
Date Posted: October 26, 2010 at 9:26 PM

thanks!!!

 ill try it tomorrow

  regards

 E




Posted By: lapolvora
Date Posted: November 11, 2010 at 3:36 PM

HI everyone, i got everything almost done just having a doorpin problem on the ready mode.

i found the solution but how do i wire the relay? any input will be appreciated, thanks!

 R.A.P. SHUT DOWN  GREEN/ violet  In Blue plug at fuse/junction block under driver's side dash     
  This is the driver's doorpin and it rests at ground (-) with the door closed. Use a relay to open this wire which will simulate the door opening and shut down the radio.


Print Page | Close Window