2010 dodge nitro

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124136
Printed Date: May 08, 2025 at 3:29 PM

Topic: 2010 dodge nitro

Posted By: fdny136
Subject: 2010 dodge nitro
Date Posted: October 26, 2010 at 3:13 PM

install is 2010 dodge nitro. I have a compustar 6200s and blade al for the install.This is the first time I am using this unit for the first time,prior I have used dei products mostly 561 valet and key in box .anything special I need to use for this install? do I need all the wiring or just the main power ign harness and can wires? thanks so much

Replies:

Posted By: kreg357
Date Posted: October 26, 2010 at 5:38 PM

From the Compustar, connect power, ground, hood pin, parking lights (right & left with 8 Amp diodes ), horn and ignition ( thru the 5 Amp fuse ). If it is a manual transmission, you will have to bypass the clutch. The blade connector has the three connections shown. Most everything is done thru data via the CAN bus.

Make sure you flash the CH5 firmware onto the Blade AL. While you are at that iDatalink screen you can also set any Compustar programming options needed.

-------------
Soldering is fun!

Posted By: fdny136
Date Posted: October 27, 2010 at 10:51 AM

i have the unit installed as described ,does the compustar have a nuetral safety? as the door locks and parking lamps work but car will not crank? also can bus h on my vehicle is white black not white light green at immobiliser.does the starter wire from 6500 get tied in? thanks

Posted By: fdny136
Date Posted: October 27, 2010 at 11:01 AM

nvm thanks just had to program tach