autopage

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124188
Printed Date: June 20, 2025 at 2:55 AM

Topic: autopage

Posted By: and0b
Subject: autopage
Date Posted: October 29, 2010 at 10:49 PM

I bought remote starter of Autopage C3-RSTKE-900, but I think I made mistake. I'm inquiring by phone(living messages ) and email with their Customer Support(???) but they just ignore me. I'm not sure which Bypass Module will work with this RS, which one will be the best. Can someone help me with that? I have Mercury Mariner 2007.

Andrew

Replies:

Posted By: howie ll
Date Posted: October 30, 2010 at 2:01 AM

DEI do either the CANMAX 400 (Ford 1 V1.0) or DB-AL (401 V1.01).
The first is an immobiliser + giving you many of the R/S functions without having to wire all around the vehicle. The second is cheaper just giving you the b-pass you require.
Autopage use idatalink. Go to their web page.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: kreg357
Date Posted: October 30, 2010 at 9:17 AM

Most manufactures will only support authorized dealers. That could be why you aren't getting a response.

The Autopage remote start should be D2D compatible with the iDatalink bypass modules. Look for an ADS-TBSL TI bypass module. All of the iDatalink moduiles listed for your car will only take care of the PATS3 immobilizer. Aws Howard suggested, here is a link to the iDatalink web site for more info and to download their install guide. https://www.idatalink.com/helpdesk/

Any bypass module will work with the Autopage unit in W2W mode. Other bypass choices are PKFM, PKALL and KEY-OVERIDE-ALL. There are other bypass modules available but they require a special USB cable to program with the correct firmware ( the ones listed above don't ).

-------------
Soldering is fun!

Posted By: and0b
Date Posted: October 30, 2010 at 9:39 AM

Thank you for quick reply. I was checking IDatalink website but there is 8 Bypass Modules which will fit my car, but which will work with my RS? Pictures shows so some of them looks like memory cards, I'm not sure where I can insert them - to the car or RS.

Thank you

Posted By: kreg357
Date Posted: October 30, 2010 at 9:59 AM

The long answer is: The Solo series will work and will come with the correct firmware pre-loaded. The Multi series will work but you must first program ( flash ) them with the correct firmware for your application with the special USB cable. The Blade series are for Compustar remote starters ( CM5x00 and CM6x00 ) only.

The SOLO series ADS TBSL TI or the ADS TBSL KO would be the best / least expensive bypass' for you from iDatalink.

-------------
Soldering is fun!

Posted By: and0b
Date Posted: October 31, 2010 at 10:40 AM

Thank you Kreg357.

Andrew