2011 lincoln mk s rem start
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124651
Printed Date: May 10, 2025 at 2:43 AM
Topic: 2011 lincoln mk s rem start
Posted By: mustyk@att.net
Subject: 2011 lincoln mk s rem start
Date Posted: November 25, 2010 at 8:56 AM
I recently installed a remote start into a 2011 Linc MK-S with a OL-MDB-ALL with FM v1.3 firmware but I have two problems: The car will not start when any of the doors are open (tech support-OMEGA_LINK says its not their unit causing this) and the car WILL start every time but it takes literally 24 seconds to start the car. Any help??
-------------
thetopinstaller
Replies:
Posted By: chev104275
Date Posted: November 25, 2010 at 9:29 AM
How did you wire everything ? I've done a bunch of these with both the ford add on starter and dei stuff. There is a yellow/orange wire at the start switch it's a negative trigger that will start and stop the car Also you need to isolate the brake wire so the car sees the brake signal but the starter doesn't Also I use dei 1101T. So I can't help you with your bypass but I've noticed I depends on placement of the module under the dash whether the car gets the signal right away or not
-------------
If i Can't Install it I Don't need it Joe
Posted By: mustyk@att.net
Date Posted: November 26, 2010 at 6:56 AM
I uploaded a .pdf document detailing how I hooked it up. And yes I used the yellow orange wire for start.
-------------
thetopinstaller
Posted By: chev104275
Date Posted: November 26, 2010 at 10:39 AM
where did you upload the file to ?
-------------
If i Can't Install it I Don't need it Joe
Posted By: mustyk@att.net
Date Posted: November 28, 2010 at 8:32 PM
I guess it didn't go thru-I'll try again----I havent been able to figure out how to attach a doc yet
-------------
thetopinstaller
|