compustar remote start and 8l3z 19g365 ba

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124655
Printed Date: May 01, 2024 at 7:04 PM

Topic: compustar remote start and 8l3z 19g365 ba

Posted By: doozer
Subject: compustar remote start and 8l3z 19g365 ba
Date Posted: November 25, 2010 at 11:41 AM

I'm reinstalling Compustar 2W900FM-RSA remote start alarm and using a 8L3Z-19G365-BA bypass. I'm reinstalling because it was originally in my 2008 truck that I traded in on a 2010. I have most of the instuctions for reinstalling except that of the bypass. I know how to install the wring over ignition key slot. I'm just verifying that the remaining Black wire is to be grounded and the red is to receive power. Is this correct?

How and does this bypass actually interface with the alarm...or does it? And if so how would it?

Thanks

Mike

Replies:

Posted By: chev104275
Date Posted: November 25, 2010 at 11:46 AM

I've never dealt with compustar but the bypass needs red to constant 12volts and black should go to a wire either called ground when running (GWR) or status output. You will need 2 programmed keys to program it. What kind of truck is this ? Ford?

-------------
If i Can't Install it I Don't need it Joe

Posted By: doozer
Date Posted: November 25, 2010 at 4:21 PM

Its a 2010 Ford F350. I do have a (-) 250mA Status Out (GWR) wire. I seem to remember connecting to this black wire.

I will try it when I get to that point and update this thread with my results.

Thanks for your help!

Posted By: doozer
Date Posted: November 25, 2010 at 4:26 PM

chev104275 wrote:

... You will need 2 programmed keys to program it....

Joe,

I do have two programmed keys can you tell me the procedure for programming the module?

Thanks

Posted By: chev104275
Date Posted: November 25, 2010 at 4:38 PM

put the first key in turn it to ON position wait for the theft light to go out within 5 seconds put the next key in and wait for the theft light to go out again within 5 seconds pull the key out and hit the remote start button if done correctly it will start

-------------
If i Can't Install it I Don't need it Joe

Posted By: doozer
Date Posted: November 25, 2010 at 8:24 PM

Thanks. I appreciate the help.

Posted By: chev104275
Date Posted: November 26, 2010 at 5:28 AM

Anytime

-------------
If i Can't Install it I Don't need it Joe