2006 mazda 6 factory alarm/ disarm 451m?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124779
Printed Date: June 01, 2024 at 8:39 AM
Topic: 2006 mazda 6 factory alarm/ disarm 451m?
Posted By: dcman41
Subject: 2006 mazda 6 factory alarm/ disarm 451m?
Date Posted: December 02, 2010 at 3:52 PM
Im getting ready to prewire a remote star for a mazda. I plan on using the dei 451m Does anyone know if the factory alarm disarm wire will also unlock / lock the vehicle or will i have to wire up additional relays for that too? Also i believe this is a negative multiplex system, and i just wanted to confirm that i will be usin diagram h located in 451m manual https://www.the12volt.com/installbay/file.asp?ID=726
Any input os appreciated thanks
-rob
Replies:
Posted By: dasbogie
Date Posted: December 02, 2010 at 4:09 PM
there is a blue wire in the driver kick white plug that will disarm and unlock
-------------
Advanced
Posted By: dcman41
Date Posted: December 02, 2010 at 4:21 PM
Perfect, do you know what value resistor i need? Or is itna straight pulse?
Posted By: dasbogie
Date Posted: December 02, 2010 at 4:47 PM
Bulldog lists a green wire which i did not test for as I didn't need doorlocks, just disarm but it is in the same plug. They list 1k ohms to lock and straight ground to unlock. The blue wire I used was straight ground
-------------
Advanced
Posted By: dcman41
Date Posted: December 02, 2010 at 5:27 PM
Directechs says Lt green is the lock/unlock wire . It does not mention about the doors unlocking with factory arm/disarm. Directechs lists Blue or blue / white as factory arm/disarm. Again this does not state that it actually unlocks/locks the car. Can anyone confirm that there is a wire that will unlock/disarm, and lock/arm? Or should i just wire up two more relays for the factory alarm/disarm wires ?
Posted By: dcman41
Date Posted: December 02, 2010 at 6:09 PM
ON a second note ive done some searching that the blue/white wire can be used for factory alarm arm/disarm along with lock/unlock when triggered thru a 750 ohm resistor.
|