ground when running output for 2 function
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124796
Printed Date: July 07, 2025 at 7:55 PM
Topic: ground when running output for 2 function
Posted By: frankspeed420
Subject: ground when running output for 2 function
Date Posted: December 03, 2010 at 6:47 PM
Hi, Im planning on installing a Skytek Galaxy 2000rs-m in a 2006 toyota corolla and have 2 questions. The first is real simple. i cant find a wire chart for it, but think its the same as an 05.
Secondly and most important is the ground when running output. I believe I need this wire to run both the bypass kit and the clutch switch bypass. I was wondering if I needed to use diodes or if the relays will keep the signals seperate.
This will be my first manual install and want it to go smoothly. Thanks in advance.
Replies:
Posted By: kreg357
Date Posted: December 03, 2010 at 6:51 PM
Toyota Corolla 2003 thru 2008 are the same. Here is a link to Bulldog Security for info : https://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp------------- Soldering is fun!
Posted By: frankspeed420
Date Posted: December 04, 2010 at 9:22 AM
thanks, what do you think about splitting the grw output? I may need it for the keysense too....
Posted By: kreg357
Date Posted: December 04, 2010 at 11:58 AM
Definitly need to diode isloate with keysense. You don't want the clutch to bypass and the transponder bypass module coming on when you put the key in the ignition for a regular start up. Keysense is usually only needed if the car has the Factory Alarm.
-------------
Soldering is fun!
|