Print Page | Close Window

astrostart 3106, vss 100 stopped working

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124833
Printed Date: May 15, 2025 at 5:49 AM


Topic: astrostart 3106, vss 100 stopped working

Posted By: luckyj
Subject: astrostart 3106, vss 100 stopped working
Date Posted: December 05, 2010 at 9:43 PM

Hello,

I have an Astrostart 3106.  A couple of months ago my battery went dead.  After getting a new battery the remote start/alarm did not work.  I was able to get some instructions for re-programming the 3106 so I first reset it.  I then did some basic programming to select the right engine configuration and I was able to get the remote start to work.  However, I can't get the alarm to work.  When I press the remote, the doors lock/unlock but the alarm istelf will not arm (the LED light does not flash and I can open the locked door without the siren going off).  I have looked under the dash and there is a smaller box next to the 3106 module which I am assuming is the VSS-100 module.  The alarm/remote start is circa 1998-2000.  I bought the truck with it already installed and this has been the first issue I've ever had with it.  Does anyone have any experience with these alarms and do you might know what I need to do to get the alarm working?  Any help would be greatly appreciated.  Thanks in advance.




Replies:

Posted By: KarTuneMan
Date Posted: December 05, 2010 at 9:51 PM

The 3106 is a remote start WITH an integrated alarm....

check the alarm programming in level 14.

What type of vehicle.... ?



-------------



Posted By: luckyj
Date Posted: December 06, 2010 at 7:06 PM

Thanks for the response.  It's a 98 Dodge Ram.  I am not sure about Level 14.  The only programming notes I have are for the command start and they only go up to Level 8.


Print Page | Close Window