anyone get defrost to work in an integra
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124962
Printed Date: April 26, 2024 at 7:48 PM
Topic: anyone get defrost to work in an integra
Posted By: riken1
Subject: anyone get defrost to work in an integra
Date Posted: December 10, 2010 at 2:16 PM
found the wire that the switch takes to ground when it's pushed. I wired the remote starter defrost output(-) to it. It doesn't work, neither does pushing the button while the car is remote started. When i turn the key to ACC, i can hear the relay energizing when i push the button.
Does something in the defrost circuit have to be energized for this to work?
Replies:
Posted By: JWorm
Date Posted: December 10, 2010 at 10:04 PM
Sounds like you need to energize another Accessory wire in the ignition harness with the remote start. Without looking at a chart, I'm thinking either WHITE/ black or yellow wire.
I had a 97 Integra about 10 years ago. I do remember having hooked up the rear defrost to my remote start. Also controlled the moonroof through the remote. It was a fun car to drive.
Posted By: riken1
Date Posted: December 10, 2010 at 11:27 PM
the yellow is for Accessory 1, but there's no mention of an Accessory 2. I don't have any wiring diagrams for the car.
Posted By: riken1
Date Posted: December 15, 2010 at 8:05 PM
this is how i have it wired.
H3/1 IGN 1
H3/2 not used
H3/3 ACC 1
H3/4 STR
H3/5 12+
H3/6 not used
H3/7 not used
H3/8 12+
should the flex relay inputs be used for defrost to work?
Posted By: scrtcell
Date Posted: December 15, 2010 at 8:25 PM
turn the key to the on position and test to see which wire has voltage and make sure that your remote starter is connected to the correct wires
Posted By: JWorm
Date Posted: December 15, 2010 at 8:55 PM
In the harness you listed above the red, RED / white and RED / black all need to go to constant 12v
Posted By: riken1
Date Posted: December 15, 2010 at 9:31 PM
its a 5301 btw.
so, H3/2 RED / white, fused IGN 2/flex relay input should be 12+? but i don't have IGN2 hooked up. Just IGN1 and ACC1 and both are supplying 12+ when remote started.
Posted By: riken1
Date Posted: December 16, 2010 at 3:35 PM
i found the WHT/BLK wire from the ignition switch that goes to 12+, but it only powers the radio/cigarette lighter.
i think my problem has to do with the Intigrated Control Unit that controls the defrost relay and timer via controlling its ground.
|