dball, 5301 remote start, 2011 sonata

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124975
Printed Date: May 09, 2024 at 5:39 AM

Topic: dball, 5301 remote start, 2011 sonata

Posted By: joeeey
Subject: dball, 5301 remote start, 2011 sonata
Date Posted: December 11, 2010 at 11:45 AM

I am installing a Expresskit DBALL module & DEI 5301 R/S on a 2011 Sonata w/smartkey. I have the tech sheet but from the schematic diagram the DBALL wiring states I do not need to use the heavy gauge wires for the remote start?? Is this correct? Or will I need to add them along with the DBALL wiring?

Replies:

Posted By: sean11901
Date Posted: December 11, 2010 at 11:59 AM

if your using D2D you will only need to hook up:

2x heavy guage Power wires (red)- which will connect to the I/P junction box Pin 13 (RED) on the plug to the bottom left

the heavy guage (+) ignition wire from the remote start to the Dball modules pin 9 (pink) on the 10-pin plug.

and then tap into that ignition wire with a diode isolated wire (diode band facing the wire you just tapped(ignition wire)

connect that wire to pin 11 (Pink) which is in the plug to the right on the I/P junction box

Posted By: joeeey
Date Posted: December 11, 2010 at 12:11 PM

Thanks, you just saved me a ton of extra wiring.

Posted By: sean11901
Date Posted: December 11, 2010 at 12:16 PM

no problem

Print Page | Close Window