2002 Toyota Camary Le Door Trigger
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125
Printed Date: June 10, 2024 at 7:42 PM
Topic: 2002 Toyota Camary Le Door Trigger
Posted By: sburro2
Subject: 2002 Toyota Camary Le Door Trigger
Date Posted: March 23, 2002 at 8:13 PM
Some research revealed that this vehicle has 3 door trigger points that should be used and diode isolated. Door Trigger Driver RED / Green Lower Left of Fuse Box (Diode)
Door Trigger Passanger RED / Green Upper Left of Fuse Box (Diode)
Door Trigger Rear RED / White Bottom of Fuse Box (Diode) Where should I make my connections (after the timer) that would ensure the interior lights flash correctly when the alarm is triggered. Any related info would greatly be appreciated....
Replies:
Posted By: tech_advice
Date Posted: March 25, 2002 at 6:18 PM
The program I have at home say Lock=blue / YELLOW, driver's kick, and Unlock=blue, driver's kick, both wires being a negative pulse....hope this helps...
-------------
Don't share too many install secrets with your customers, pretty soon they won't need you!!!!!
Posted By: tech_advice
Date Posted: March 25, 2002 at 6:21 PM
Sorry, I was reading another and answered yours wrong...
-------------
Don't share too many install secrets with your customers, pretty soon they won't need you!!!!!
Posted By: wirewise
Date Posted: March 25, 2002 at 7:10 PM
Connect to the rear door drigger or directly to the dome lamp lead behind the driver's side pillar or directly behind the light. Any of these locations will work.
~~wirewise~~
Posted By: sburro2
Date Posted: March 25, 2002 at 7:36 PM
Wirewise, The rear door triggers still delay the dome turn off, so it seems not to be a good connection point. I have found the three wires leading to the dome in the drivers pillar. I hate to confess, I have no clue how to make it work at that connection point. Thanks in advance...
Posted By: wirewise
Date Posted: March 25, 2002 at 8:19 PM
Measure each wire found in the pillar. The one that shows 12V+ when all doors are closed and shows ground when any door is open is the switched lead to the dome lamp. Once you find this wire you can test it further, again with all doors closed, by applying ground to it and the dome lamp should turn on. As soon as you remove ground from the wire the dome lamp should turn off.
Thanks btw... I'll make a note on that rear door trigger.
~~wirewise~~
Posted By: sburro2
Date Posted: March 26, 2002 at 5:17 AM
That did it. !!!!! Thanks for the advice...........
|