dei blue led alarm light

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125031
Printed Date: May 21, 2024 at 9:38 AM

Topic: dei blue led alarm light

Posted By: gregbbb
Subject: dei blue led alarm light
Date Posted: December 14, 2010 at 2:16 AM

Can any one tell me how to get the blue cap off a viper LED alarm light so you can just mount the small LED glass pin head? I dont want to mount that big blue tip And what do you use to hold it in glue? I have seen it in cars just dont know how to do it.

Thanks!!

Replies:

Posted By: KPierson
Date Posted: December 14, 2010 at 10:24 AM

There is a small plastic holder piece in between the wires of the LED. Use a sharp straight pick and remove the holder piece. With that piece out the LED will pull out.

I prefer to use a 7/64" bit and press fit the LED in with no glue or adhesive. You have to be careful though not to make it too tight, as I have seen them not work if the fit is extremely snug.

Oh, and the LED is plastic, not glass!

-------------
Kevin Pierson

Print Page | Close Window