2000 windstar remote start problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125085
Printed Date: June 01, 2024 at 11:27 AM

Topic: 2000 windstar remote start problem

Posted By: edzwasel329
Subject: 2000 windstar remote start problem
Date Posted: December 17, 2010 at 12:02 AM

i have ford 2000 windstar and i stalled a prostart ct-3471, ill check all wire color are correct, but its does'nt start when the ignition key are not in the igniton barrel, and heater fan, and park light is not working also! anybody to figure out this... thank's for your help merry x-mass!!

Replies:

Posted By: zerepdivad
Date Posted: December 17, 2010 at 12:02 AM

it doesn't start without the key in the barrel? hmm think about that one for a second....

-------------
A DMM is a beautiful thing.

MECP Advanced Installer Certified.

Posted By: edzwasel329
Date Posted: December 17, 2010 at 12:11 AM

what is the best way and i need an additional part to start it w/out the key?

Posted By: edzwasel329
Date Posted: December 17, 2010 at 12:14 AM

actually i have also a 1999 dodge caravan and i stalled it. everything works fine! not on my ford windstar..

Posted By: zerepdivad
Date Posted: December 17, 2010 at 12:32 AM

buy a pkall

-------------
A DMM is a beautiful thing.

MECP Advanced Installer Certified.

Posted By: tedmond
Date Posted: December 17, 2010 at 8:37 AM

windstar uses multiplex (resistive) parking lights, there are mutiple ignitions and accessories, so power them all up as INDIVIDUAL circuits or else the heater wont run

as far as bypass, you will need 2 keys for programming. use anything from idatalink, fortin, or expresskits.

-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert

Posted By: tommy...
Date Posted: December 17, 2010 at 9:38 PM

You can use the FLTBF or the 556U for the bypass...(Must give up a key for the 556u)...You have not properly wired the ignition harness to the r/s harness...Take the time and post your connections...! Do you have a DMM or just praying that it's right...? You will need to wire up relays to power the "extra" ignition and accessories wires...Look on on this site under relay's for that info...!

Remote Start
WIRE	COLOR	POLARITY	LOCATION
Battery	LIGHT GREEN/ VIOLET	(+)	IGNITION SWITCH HARNESS
Ignition 1	WHITE/ YELLOW	(+)	IGNITION SWITCH HARNESS
Ignition 2	VIOLET/ORANGE	(+)	IGNITION SWITCH HARNESS
Accessory 1	VIOLET/ORANGE	(+)	IGNITION SWITCH HARNESS
Accessory 2	YELLOW	(+)	IGNITION SWITCH HARNESS
Accessory 3	BLACK/ GREEN	(+)	IGNITION SWITCH HARNESS
Starter 1	GREEN	(+)	IGNITION SWITCH HARNESS
Anti-Theft Type	RF ACTIVATED SYS.
Anti-Theft Descript	PATS
Key Sense	BLACK W/ VIOLET DOTS	(-)	IGNITION SWITCH HARNESS
Neutral Safety	WHITE/ PINK	(-)	USE STARTER WIRE
Tachometer	PINK/WHITE	(-)	PCM RIGHT SIDE INST PNL PIN 78(2 CYL SET
Speed Sense	GREEN / WHITE	(AC)	PASS REAR OF ENG POS 58 OF 104 PIN PLUG
Parking Lights	YELLOW/LIGHT BLUE	(-)	PIN 21 OF 22 PIN CONN FRONT BCM LEFT DAS
Low Crr. Pk Lights	BLACK/ GREEN	(-)	HEADLIGHT SWITCH
Brake Lights	RED / LIGHT GREEN	(+)	AT SWITCH ABOVE BRAKE
Reverse Lights	LR:GREEN/ ORANGE	(-)	RR:WHT/YEL PIN 9+10 OF 17 PIN REAR BCM
	MAY ALSO BE WHITE/ YELLOW
Horn	ORANGE / RED	(-)	PIN 8 OF 12 PIN CONN FRONT BCM
Modules
WIRE	LOCATION
Module 1	HIGH DR.KICK
Module 2	BCM - LEFT SIDE OF DASH (FRONT) RIGHT REAR QUARTER PANE FRONT ELECTRONIC MODULE (FEM)
Module 3	PCM - RIGHT SIDE OF DASH

-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!