2006 ram, python 1401, chall
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125142
Printed Date: July 14, 2025 at 4:16 PM
Topic: 2006 ram, python 1401, chall
Posted By: opelap
Subject: 2006 ram, python 1401, chall
Date Posted: December 19, 2010 at 1:58 PM
Finally got all my equipment and am about ready to install. Just would like to verify some of the connections I am making. I am installing in D2D.
Red H1/2 12V Constant ----- Positive Battery terminal
Black H1/5 Chassis Ground ------ Ground point in vehicle
WHITE/ Brown H1/4 Parking lights Isolation ----- Switch side of parking lights wire
White H1/11 Parking light Output ------ vehicle side of wire with 1K ohm resistor
Pink H3/1 Ignition 1 input output ----- Yellow CHALL ign 1
Do I need to hook up any other power on the H3? Different gauge of the two wires has me concerned.
Violet H3/4 Starter (+) ------- Starter (+) in vehicle ignition
WHITE/ black CHALL ----------- PURPLE / brown MUX wire in ignition
Anything I am missing? CHALL is rev 2.01 and does not show using a relay to isolate the MUX line, however, the latest instructions on the website do?
Thanks for the help.
Phil
Replies:
Posted By: opelap
Date Posted: December 19, 2010 at 2:35 PM
Also the latest version of CHALL install show using Ign 2 to the Ignition line on the vehicle.
Do I need to hook up the Ign 1 and Ign 2 30A fused inputs on the H3?
|