push to start toyota camry 2010

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125168
Printed Date: July 18, 2025 at 1:04 AM

Topic: push to start toyota camry 2010

Posted By: Thack79
Subject: push to start toyota camry 2010
Date Posted: December 20, 2010 at 5:21 PM

Using Avital 1 way remote start/keyless (4103) and the idatalink ADS-AL(DL)-TL1 (type 3)

is the only wire coming from the thick gauged remote start wiring is the two 12volt red, pink iginition (connected to pin 7 of the ECU), and the purple stater wire (connected to the bypass and NOT the car)?

any other suggestions or pointers with this car.

greatly appreceiated,

jason

Replies:

Posted By: Mike M2
Date Posted: December 20, 2010 at 6:31 PM

You are correct. Wire it exactly as stated in the TL1 manual and it will work fine. Get power from the fuse box power wire, be sure to add the diode. No other connections to the car are needed as the TL1 software does it all for you thru CAN data...

-------------
Mike M2
Tech Manager
CS Dealer Services

Posted By: Thack79
Date Posted: December 20, 2010 at 7:01 PM

whats the deal with the auto lights i here with his car (and the highlander i believe)? ive heard/reading of people opening the auto wire, pulsing door pins, etc.

Posted By: Mike M2
Date Posted: December 21, 2010 at 5:22 PM

If the auto lights are left on when it remote starts they will not shut off because they don't see the drivers door open and close to start the timer. You can either pulse the driverrs door pin after the RS shuts off, or do like i do and add a relay to break the auto light wire whenever the RS is on....

-------------
Mike M2
Tech Manager
CS Dealer Services

Posted By: tianot
Date Posted: December 21, 2010 at 10:51 PM

hey mike, how to add relay on that one, the auto light?

thanks

-------------
tianot

Posted By: tedmond
Date Posted: December 22, 2010 at 7:18 AM

take a relay

85 - GWR
86 - constant 12v
Cut the autolight wire
87a - autolight wire switch side
30 - autolight wire light side

i ususally just pulse the driver door pin OR you can pulse the autolight shut off wire at the switch as well. I beleive its red (-). I will check that foryou again.

-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert