bypass on ’07 pontiac g6
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125186
Printed Date: July 05, 2025 at 7:37 PM
Topic: bypass on ’07 pontiac g6
Posted By: tombosley
Subject: bypass on ’07 pontiac g6
Date Posted: December 21, 2010 at 11:52 AM
I am installing a remote start on wifes car. First off, bad idea. Things went well, until time for the bypass. I am driving myself up a wall trying to get the bypass module hooked up on a 07 G6. Is there a picture out there somewhere where to locate these wires? any help is greatly appreciated, her car is in pieces,
Replies:
Posted By: tombosley
Date Posted: December 21, 2010 at 12:32 PM
I think i have located the pin harness for the remaining wires but absolutely ridiculous location? waaay up under the dash past the ignition clip? is this right?
please help. wife getting mad
Posted By: kreg357
Date Posted: December 21, 2010 at 4:58 PM
It would help to know which bypass module and remote starter you are using. The connections should be at the Main Ignition Harness and the OBD2 connector. White wire is Passlock2, Brown wire is ACC and Pink wire is IGN.
-------------
Soldering is fun!
Posted By: tombosley
Date Posted: December 21, 2010 at 5:06 PM
Bypass is xk06 got a few hooked up on small green plug. But couple others need black six pin connector. Please help
Posted By: kreg357
Date Posted: December 21, 2010 at 5:28 PM
Remove lower steering column clam shell cover for access. This info from the PKG7 install guide :
These connectors are located in back of the ignition switch.
Should be right there. Does your ignition key have a PK3 or a "+ in a circle" stamped on it? Here is a link to Bulldog Security. https://www.bulldogsecurity.com/bdnew/vehiclewiringdiagrams.asp Look up your car. They have some pictures to help locating some of the necessary wires. ------------- Soldering is fun!
Posted By: tombosley
Date Posted: December 21, 2010 at 6:25 PM
system is all hooked up but will not work. all wires are good but were not getting power to bypass or scytek system. the red wires going into the brain unit are getting power but no lights on on the bypass or antenna. any ideas?
Posted By: kreg357
Date Posted: December 21, 2010 at 7:02 PM
Sorry, not familiar with the SkyTek systems at all.
-------------
Soldering is fun!
Posted By: tombosley
Date Posted: December 21, 2010 at 7:09 PM
Car will remotely start but won't shut off. Even with key or brake pedal. Only way is to unplug bypass. So close any Masters out there know problem?
|