frontier 2004

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125228
Printed Date: May 10, 2025 at 6:57 AM

Topic: frontier 2004

Posted By: muaiad97
Subject: frontier 2004
Date Posted: December 23, 2010 at 9:30 PM

hi all

i installed remote starter in this truck its frontire 2004 the starter working good and also the door locks and i finished evrything after testing the remote starter was working fine no problem and befor i call the costomer to pick it up i noticed some problems and it when i start the truck with remote it working but i tried to turn the key to on position the truck is grinding and when i push the brake without the key its doing the same thing and also happens when the car shuts off with the remote starter .so what i did i isolate the starter wire i mean when the truck running under the remote starter the starter wire is off but still the same problem when the time for remote starter out i hear the truck grinding .

any help please

Replies:

Posted By: kreg357
Date Posted: December 24, 2010 at 4:18 AM

Not sure if this will help, but here are some older posts on a similar problem :

https://www.the12volt.com/installbay/forum_posts.asp?tid=46277&DIR=N&fid=3

https://www.the12volt.com/installbay/forum_posts.asp?tid=98121&KW=NowYaKnow

-------------
Soldering is fun!

Posted By: zerepdivad
Date Posted: December 24, 2010 at 5:27 PM

relay isolate the accessory wire i believe it is. very common issue on nissans.

-------------
A DMM is a beautiful thing.

MECP Advanced Installer Certified.

Posted By: muaiad97
Date Posted: December 24, 2010 at 9:39 PM

thank you for helps

the first issue i fixed it which is turning the key to on it grinding and i still have 2 problem which is when the car shuts off with remote starter it grinding and also when i push the brak padel befor inserting the key to ignition. do i have to isolate the acc wire or ignition wire.