07 camry, remote starter
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125336
Printed Date: November 04, 2025 at 4:32 AM
Topic: 07 camry, remote starter
Posted By: turtle02909
Subject: 07 camry, remote starter
Date Posted: December 30, 2010 at 12:23 AM
Hello peeps, I am confuse with the 2nd starter relay diagram. Where 87-12 volts
85-Primary starter wire
86-To car starter's ground out(-)when running
30-2nd starter wire
My problems is #86 to car starter's ground out(-)when running.
Which wire to I connect this to? Is this negative ground from the metal of car? or from the remote starter module that has (-)200ma second starter turn on wire?
Replies:
Posted By: resquchas
Date Posted: December 30, 2010 at 3:28 AM
that diagram seems wrong. pins 85, and 86 should be low voltage coil field pins. this seems more correct.but it depends on yor application.
85- 12volt
86- gwr - from alarm( it goes to the alarm/rs wire not the car or it will always be on. this is the switch wire)
what are you installing. you have to be specific.
-------------
The RIGHT way is the ONLY way.
Posted By: howie ll
Date Posted: December 30, 2010 at 4:57 AM
2nd starter wire 200mA to 85.
Ign 1 to 86
30amp fused to 87
Second starter wire from 30
1N4004 diode across 85 and 86, band towards 86.
How many more times does this have to be answered.
Check the archives please.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: turtle02909
Date Posted: December 30, 2010 at 2:29 PM
Where is the tach and rear defrost wires on 07 Camry?
Posted By: howie ll
Date Posted: December 31, 2010 at 6:03 AM
Either rear of tach on instrument panel, engine management pin 9 on your OBD data connector or one of the dissimilar wires at the injectors.
Defrost wire, check from rear window going forwards.
This is where your DMM gets used.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
|