push button door popper

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125354
Printed Date: May 14, 2025 at 10:51 PM

Topic: push button door popper

Posted By: mightymouse35
Subject: push button door popper
Date Posted: December 30, 2010 at 6:30 PM

shaved door handels n hooked up autoloc door poper kit. now im lookn to delete interior handles and use a push button momentary switch in my console to open doors. how would i do this ..thanx

Replies:

Posted By: howie ll
Date Posted: December 31, 2010 at 11:37 AM

If just to open, wire as follows:-
Ground to switch to 85
Cut unlock motor wire (that's the one that shows 12volts+ only when you unlock it).
Control unit side to 87a
Motor side to 30
12V+ constant, 15 amp (per motor) fused to 86 and 87.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Print Page | Close Window