Any one programmed Alpines?

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=12550
Printed Date: September 19, 2025 at 11:17 AM

Topic: Any one programmed Alpines?

Posted By: turd
Subject: Any one programmed Alpines?
Date Posted: April 22, 2003 at 6:38 AM

I just installed my Alpine SEC-150R into my classic stang; once it is painted, I will finish hook-up and need to program it.

The install sheet has some instructions for programming it, as well as the box top...........BUT, if there is any one who has programmed lots of these......can you explain the basics to a complete idiot???

Thanks

Replies:

Posted By: CCRoadshop
Date Posted: April 22, 2003 at 7:00 AM

ive been installing now for 2 1/2 years...... Programming Alpines suck, and I still hafta look at the book to program them.....

have fun lol

-------------
Installer - Circuit City Roadshop(2 1/2 years n counting)
------------------
Alpine CDA7894(soon to be the cda9815)
Pioneer XM unit(soon to be direct link alpine)
Audiovox 995C alarm/remote start

Posted By: turd
Date Posted: April 22, 2003 at 9:00 AM

So, would it be better if I just brought my car to the local Alpine installers and paid them to program it for me???

How much do you think it would cost to get it programmed.....I only need to change doors to positive trigger, and adjust sensitivity?

Posted By: 2k2AccordEX
Date Posted: April 23, 2003 at 2:26 AM

For the Alpine alarms( SEC-100S or SEC-150R), the adjustment of the shock sensor is easy; use the valet switch and the buttons on the remote to increase or decrease the sensitivity of the alarm. If you read the box top carefully you should be able to figure out how to do it. Also to change the polarity for the door sensor, just toggle your way through the menu of the alarm setup, should take a few mins to do so. As for a shop programming your alarm for you, it would usually be a flat rate charge (Ex: $30.00).

-------------
If I have an idea, and you have an idea and we share ideas, then we each have two Ideas, together we have four.

Posted By: turd
Date Posted: April 23, 2003 at 9:38 AM

Thanks.

I will try to program it, but if all else fails, I will get the pros to do it.