06 trailblazer remote start problem

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125537
Printed Date: July 20, 2025 at 2:25 AM

Topic: 06 trailblazer remote start problem

Posted By: cinjo
Subject: 06 trailblazer remote start problem
Date Posted: January 08, 2011 at 5:30 AM

Hi everyone, another remote start problem. I installed a Bulldog RS 82 with a PLJX bypass in my 06 TB. Wired everything up exactly as the directions called for but I have 2 problems no one can help with. Of course I can not get any response from Bulldog either.

1. When remote starting, vehicle will start for a second or 2 then shut off. It will do this 3 times and stop.Is this a tach problem (I am using tachless mode), Passlock II, or something else?

2. When programming with the Bulldog remote, brake applied and stop button pressed, the starter engages for a second every time.

I have installed a few remote starts before , even installed the RS82 in my 99 Tracker last month with no problems. I just can't seem to get this one.

Any help is appreciated and thank you.

Replies:

Posted By: dasbogie
Date Posted: January 08, 2011 at 7:41 AM

run a tach wire, you can get it inside the car

-------------
Advanced

Posted By: kreg357
Date Posted: January 08, 2011 at 7:47 AM

Did you get wire up a relay and power the ACC2 wire?

-------------
Soldering is fun!

Posted By: cinjo
Date Posted: January 08, 2011 at 9:19 AM

The acc 2 wire is connected but there is no relay. I hooked up the tach wire this morning and now it wont do anything at all. I think will just take it out. I can only take so much.

Posted By: reecegr
Date Posted: January 08, 2011 at 10:07 AM

ADDENDUM

If you have an RS1100 or RS1200 and your vehicle runs for several seconds, shuts off, restarts, runs, and shuts off again, perform the following step: Connect the BLACK/ White tach wire (from the 16 pin plug) to the heavy gauge White Ignition 1 wire and program the unit for Tach Mode (bottom of page 19).

from bulldog website,i see its not your model byt worth a try