456l not learning
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125551
Printed Date: June 05, 2024 at 1:30 PM
Topic: 456l not learning
Posted By: onemoosehorn
Subject: 456l not learning
Date Posted: January 08, 2011 at 5:25 PM
I have a 2005 dodge ram 1500 that I installed a viper 5701 in. Everything works but I can't get my 456l to program to learn the door locks. Its wired up but all it does is keep flashing the led when I try to program it. Any suggestions?
Replies:
Posted By: Twelvoltz
Date Posted: January 08, 2011 at 6:00 PM
How did you connect your wires, they really need to be soldered.
I haven't used a 456l in quite a while, but I remember the 'programming wire' needs a clean ground to put it into programming mode. I stopped using them because resistors are easier/cheaper/faster.
------------- Installer, IT support, and FFL. I need less hobbies.
Posted By: onemoosehorn
Date Posted: January 08, 2011 at 7:24 PM
It's all soldered. User error. For programming you have to use the actual switch on the door. I misread and tried using the remote. Works great!! Love the Smartstart too! If anyone needs help with this type of install let me know.
Thanks.
|