2004 nissan pathfinder

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125566
Printed Date: June 06, 2024 at 7:09 AM

Topic: 2004 nissan pathfinder

Posted By: ricardoboston
Subject: 2004 nissan pathfinder
Date Posted: January 09, 2011 at 11:53 AM

hi guys ,need some help to hook up a xk05 pkn2 need to know what wire color goes to hook up with the bypass and location thanks

Replies:

Posted By: kreg357
Date Posted: January 09, 2011 at 7:46 PM

The transponder connector in your Pathfinder is the 8 Pin style.

On the XK05

Brown wire goes to Remote starter (-) Status Output (aka GWR, Ground While Running, etc)
Black wire goes to chassis ground
Red wire goes to +12v constant thick WHITE/ Red @ ignition harness
Pink/White wire goes to WHITE/ Black Ignition wire at Pin 7 of 8 Pin connector - cut wire Key side
Blue and Pink wires go to WHITE/ Black Ignition wire at Pin 7 of 8 Pin connector - cut wire ECM side
Violet wire goes to PURPLE / Red wire at Pin 1 of 8 Pin connector

-------------
Soldering is fun!

Posted By: ricardoboston
Date Posted: January 10, 2011 at 6:23 AM

how about the security light? do i need to hook up? if i do have to hook up it what wire goes there thanks

Posted By: kreg357
Date Posted: January 10, 2011 at 7:50 AM

The XK05 with PKN2 firmware has to provisions for the Security LED like other brands of bypass
modules. Here is a note from iDatalink concerning the Security LED :
SECURITY LED WIRE IS PRESENT ONLY
IF VEHICLE IS EQUIPED WITH THEFT
SECURITY LED. IF WIRE IS NOT PRESENT,
SECURITY LED WIRE CONNECTIONS ARE NOT
REQUIRED.

If you have Factory Theft Security and the Security LED is an issue, you could set up a relay to
open the the Security LED wire during remote start using GWR as the relay control. The Security LED
is a Brown wire at Pin 5 of that same 8 Pin connector.

-------------
Soldering is fun!

Posted By: ricardoboston
Date Posted: January 10, 2011 at 11:08 AM

thanks a lot but how to get it connected ?how to wire a relay for it ,im just whant to do it right thanks again

Posted By: kreg357
Date Posted: January 10, 2011 at 11:47 AM

What brand and model of remote starter?

-------------
Soldering is fun!

Posted By: tedmond
Date Posted: January 10, 2011 at 2:04 PM

to break the continuity on the security light

85 - gwr
86 - constant 12v
87a - security light bcm side
30 - security light cluster side

-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert

Posted By: ricardoboston
Date Posted: January 10, 2011 at 8:12 PM

you re the best ,works perfect i did like you said ,thanks