Anyone know what i can use to do this? What im trying to do is, use one output from the alarm to activate 2 different output. One ouput the first press of the channel, the second when the channel is pressed again. I installed on a Mazda MPV with sliding doors. The use a one wire system so i need to open and close off of one output from the alarm. Any suggestions? Any idea where i can find a mechanical latched relay like what is used in the relay diagram on this site?
i think a DEI 611T will do that.
the install manual is on this site.
-------------
yuk
quiet rural missouri, near KC.
If your system moves you physically and not emotionally, you have wasted your money.
Not sure what year your MPV is so I can not verify what your vehicle requires...but I think what you are looking for is a device known as a channel creator. These devices are designed to do what I think you are looking for...create more than one output from a pulse of a single output. Before remote starters had the option of choosing how many pulses would activate them I would use a channel creator for the occasional vehicle that the owner did not want to carry a different remote. I probably still have a few on the shelf in my garage. I don't think you want a latching relay setup as that would provide a constant output each time you changed the state...meaning it would continue to provide your output at all times.
-------------
Installer, IT support, and FFL. I need less hobbies.
depending on the type of output the system has you might look into a DEI 450T. it turns a single channel into 6 programmable possibilities.
-------------
yuk
quiet rural missouri, near KC.
If your system moves you physically and not emotionally, you have wasted your money.