dei 530t bench test

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125646
Printed Date: July 06, 2025 at 8:23 AM

Topic: dei 530t bench test

Posted By: laziebun
Subject: dei 530t bench test
Date Posted: January 13, 2011 at 10:13 AM

Has anyone ever bench test a dei 530t? Reason im asking is i bought a couple used ones and want to make sure they work. Instead of going through all the hassle to find out there out of commission. Here is what i did to test mine.

H1/1 red wire 12v constant
H1/5 and H1/1 were both grounded
H1/3 went to one lead of my fluke
H1/2 went to the other lead of my fluke
(had the fluke act as the window motor)
H2/4 is the ground when armed wire and i touch that to the ground and it just click a relay on and off. Same with the RED / white aux(-) wire it just trigger the relay on and off.

Does any of this sound right to anyone? To me i figured once i triggered either orange or RED / white that the relay would kick on until it saw resistance then the relay would kick off.

Replies:

Posted By: howie ll
Date Posted: January 13, 2011 at 11:19 AM

I believe you need a motor to "load" them up to make them work, easier to find a window lift or old electric aerial.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.

Posted By: itsyuk
Date Posted: January 14, 2011 at 9:03 PM

ditto.

says right in the instructions (available on this website) must be a motor.

-------------
yuk
quiet rural missouri, near KC.
If your system moves you physically and not emotionally, you have wasted your money.