2010 ford edge door trigger

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125959
Printed Date: July 02, 2025 at 11:55 PM

Topic: 2010 ford edge door trigger

Posted By: gregbbb
Subject: 2010 ford edge door trigger
Date Posted: February 01, 2011 at 9:36 AM

I am installing a viper 5901 remote start / alarm in a 2010 ford edge and going by the wiring chart on this site

the door trigger is one wire +DOOR TRIGGER GRAY/VIOLET (+) IN DRIVERS KICK PANEL
DOMELIGHT SUPERVISION GRAY/PURPLE (+) IN DRIVERS KICK PANEL or SJB, (GRAY 14-PIN PLUG(A) PIN 9, Note #2 (dont know if they are the same?)

I just got a wire diagram with my fortin bypass for the edge and they say the door triggers are four (-)door triggers whitch one is right

the install looks straight forward I just need to know what other installers do for the door trigger and doom light supervision on this suv?

Thanks!!

Replies:

Posted By: tonanzith
Date Posted: February 01, 2011 at 11:55 AM

use the dome supervision wire. + gray/purple

The SJB (Smart Junction Box) is under the driver dash. The puddle lamps wire is purple (+) in the driver kick or SJB, gray 26 pin plug (C), pin 12.

The actual door trigger wire in the 2010 edge is -/nc which is far more complicated. Using the dome supervision wire no relay or diodes are needed.

-------------
Gary Sather

Posted By: gregbbb
Date Posted: February 01, 2011 at 1:30 PM

So this gray/purple wire is the same wire that is in the kick and the Smart Junction Box and you can use this same wire for doom light and door trigger for all the doors?