Print Page | Close Window

troubleshoot 04 durango

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=125990
Printed Date: May 12, 2024 at 12:20 PM


Topic: troubleshoot 04 durango

Posted By: delco_installer
Subject: troubleshoot 04 durango
Date Posted: February 03, 2011 at 10:11 AM

I recently installed an autopage rs603 and iDatalink ADS-DL-SL-CA2 in this 04 Durango after testing everything was good but the customer is telling me that the factory alarm is going off when the car is remote started, also he states that there is a light on his dash I am not sure what the light is but if anyone could give me some ideas on how i can trouble shoot this I would really appreciate it.

Thanks



-------------
Mike



Replies:

Posted By: kreg357
Date Posted: February 03, 2011 at 10:51 AM

The iDatalink module turns off the factory alarm with the unlock command from the remote starter.   Did you program / set the remote starter to "unlock before and lock after start"?  

Did you connect the remote starter to the vehicles Keysense wire?  iDatalink install guide says that Keysense is required. 



-------------
Soldering is fun!



Posted By: delco_installer
Date Posted: February 03, 2011 at 10:58 AM
I did not hook up the keysense wire and I believe the remote start is set to lock before start

-------------
Mike



Posted By: blanx218
Date Posted: February 04, 2011 at 3:44 PM
keysense will solve the alarm going off issue. use your GWR to trigger it. its (-) PURPLE / tan at the ignition harness. as far as the "light" on on the dash did you hook up the 2nd accessory pink/purple? most Dodge's will throw idiot lights if all IGN/ACC wires arent powered


Print Page | Close Window