Print Page | Close Window

need to disable alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=126073
Printed Date: May 13, 2025 at 6:23 PM


Topic: need to disable alarm

Posted By: phillyandcars
Subject: need to disable alarm
Date Posted: February 08, 2011 at 2:57 PM

Can anyone assist me with disabling an after market alarm. i have a 1990 plymouth acclaim, the alarm that was installed in it no longer works the circuit board inside the alarm is no good. the issue is i hvae unhooked the alarm and hooked the starter wire back up to the ignition, however when i crank the car over there is no spark or no fuel. what other wires need to be hooked back up properly besides the starter wire. basically how do i rewire the car without the alarm being hooked up



-------------
phillipvaughan



Replies:

Posted By: t&t tech
Date Posted: February 08, 2011 at 4:01 PM
do you have igniton or a fuel pump cut? Did the car start fine before? Look for two wires of the same colour and gauge that are around the area you connected the starter wire and the run to the fuel pump.


Print Page | Close Window