2010 jeep wrangler

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=126396
Printed Date: July 06, 2025 at 1:38 PM

Topic: 2010 jeep wrangler

Posted By: carsolutions
Subject: 2010 jeep wrangler
Date Posted: March 02, 2011 at 9:48 AM

hi there, i need some help on this one.

we did a video deck, speaker, amps and subs on this 2010 jeep wrangler now it wont start. i seem like the clutch switch wont engage. however there is no visible switch at the pedal.

we didnt use the can iterface module to install the deck, could the can wires screw something on the bcm or somthing? we reinstall the factory deck and disconect the battery but nothing.

any sugestions? thank you.

Replies:

Posted By: Velocity Motors
Date Posted: March 02, 2011 at 9:06 PM

The clutch activation is on the engine side of the firewall. If there's a problem with the start, check to see if the Sentry LED is flashing when trying to start. Also, is the truck trying to start or not even cranking ?

-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA

Posted By: carsolutions
Date Posted: March 03, 2011 at 8:53 AM

thanks Jeff, i did find the switch but that wasnt the problem. the vehicle didnt crank at all. and the red led was off. not sure what happen in there i left the battery unplug all nigth hoping is gona reset something but nothing happen so i send the car to the dealership. hope i dont get a big bill of it. however doodie happens.

i let you know what they tell me. have a good day.

Print Page | Close Window