xk01 06 silverado no communication

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=126423
Printed Date: May 12, 2025 at 10:05 PM

Topic: xk01 06 silverado no communication

Posted By: nfrank89
Subject: xk01 06 silverado no communication
Date Posted: March 04, 2011 at 2:49 AM

I understand the xk01 is known to have problems. but i havent seen this one yet. i've got the xk tapped into the #2 pin at the obd2 connector. i've got it tapped into power and ground as well. these are the only connections i've made. the unit is loaded with AMDL firmware 6.0 red light is constant then i turn the key, the unit should blink it's vehicle type but it just remains constant. after multiple tries i had the module wiped and programmed again. i was able to get it to flash and set it to type 4 then turned the key off. after that it just remains constant and will not respond to any combo of key on's and button pushes. what should i do with this thing?

Replies:

Posted By: kreg357
Date Posted: March 04, 2011 at 6:30 AM

I sense an iDatalink convert in the making....... posted_image

Do you have a spare XK01 module to try?

-------------
Soldering is fun!

Posted By: bndawgs
Date Posted: March 04, 2011 at 7:35 AM

you should become a rep for them. get us all discounts posted_image

as far as the module goes, i would try to contact the seller you bought it from and see if you can get it exchanged.

unless the module needs more wires hooked up??

-------------
<-------- Stayed at a Holiday Inn express last night

Posted By: nfrank89
Date Posted: March 04, 2011 at 12:12 PM

kreg357 wrote:

I sense an iDatalink convert in the making.......

Do you have a spare XK01 module to try?

i haven't got an extra... ill try to contact the seller again. :/ yeah the only wires needed for the module to communicate with the vehicle are + - and data

Posted By: blanx218
Date Posted: March 04, 2011 at 12:21 PM

For GM vehicles (types 1 to 4), the LED will not flash; it will stay

ON solid. You will need to use the key and start the vehicle to turn the

LED OFF and complete the programming sequence.

The above is a note from the install guide. If you can get it to lock in the #4 mode the LED should come on solid. then release the program button and start the car with the key and the LED should go out. It is then programmed.

Also are you using D2D or W2W? The xk01 is older technology and D2D has been an issue with it

Posted By: kgerry
Date Posted: March 04, 2011 at 1:33 PM

i have used literally hundreds of XK01's on these vehicles with no issues at all.....

-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer

Owner/Installer
Classic Car Audio
since 1979

Posted By: nfrank89
Date Posted: March 05, 2011 at 1:00 AM

oh dang, really? i read the install page it came with and cant get the thing to go into any kind of programming mode to change the vehicle type or anything. havent tried starting the truck to see if it goes out, ill give it a try tomorrow!