Ok I downloaded the Installation manual, ford wire diagram.. Have most of the wires run but I still havent figured out were the Keysense wire from the truck wires into the Remote start wires..Any help would be grateful.....
-------------
greystone
I should have put this info in the first draft, ooops..
05 Ford F150
12volts lt. GREEN/ purple (20A) + ignition harness ----DONE
Starter RED / lt. blue + ignition harness ----DONE
Ignition dk. blue/lt. green + ignition harness ----DONE
Accessory BLACK/ lt. green + ignition harness ----DONE
Keysense BLACK/ pink + ignition harness
Power Lock pink / YELLOW - DKP or BCM, green plug, pin 9 ----DONE
Notes: The BCM (Body Control Module) is on the driver side rear cabin wall.
Power Unlock pink/lt. green - DKP or BCM, green plug, pin 1 ----DONE
Notes: The BCM (Body Control Module) is on the driver side rear cabin wall.
Parking Lights+ brown + switch or BCM, blue plug, pin 6 ----DONE
Notes: The BCM (Body Control Module) is on the driver side rear cabin wall.
Door Trigger BLACK/ yel (L), BLACK/ pink (R) - DKP, gray plug, pins 22, 23
Notes: The wiring above is for vehicles without keyless entry. Vehicles with keyless entry, the door trigger wires are found at the BCM, green plug. The LF door trigger is BLACK / YELLOW in pin 4. The RF door trigger is BLACK/ pink in pin 5. The LR door trigger is BLACK/ lt. blue in pin 12. The RR door trigger is BLACK/ white in pin 13. Use all wires and diode isolate each.
Tachometer NOT RED / lt. green or red ac any ignition coil or fuel injector
Brake Wire lt. green + brake pedal switch ----DONE------
Parking Brake lt. GREEN/ red - parking brake switch ----DONE------
Horn Trigger dk. blue - switch or BCM, blue plug, pin 12 ----DONE------
Notes: The BCM (Body Control Module) is on the driver side rear cabin wall.
Immobilizer Bypass Module: Required: Yes Type: SecuriLoc
-------------
greystone