2006 cadillac srx headlight stay on?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=126585
Printed Date: May 16, 2024 at 1:52 AM
Topic: 2006 cadillac srx headlight stay on?
Posted By: tianot
Subject: 2006 cadillac srx headlight stay on?
Date Posted: March 15, 2011 at 1:38 PM
hey guys!
im installing a remote starter into a 2006 cadillac srx. everything is working good after the installation, except the headlight is stay on after shutting down the engine using the remote. it will only shut off the headlight when i open the door manually and close it again.
what can i do to fix this problem? thanks ------------- tianot
Replies:
Posted By: dasbogie
Date Posted: March 15, 2011 at 3:42 PM
is the headlight switch in the autolamps setting? Is there a rearm wire you can pulse the door trigger with? ------------- Advanced
Posted By: tianot
Date Posted: May 13, 2011 at 2:14 PM
hi! there is a autolight switch. when i put the headlight switch to off position, the headlight will not on after shutting down the car using the remote but the radio still on, it will only turn off if i close the door manually.
rearm wire? you mean the rearmwire of the car? ------------- tianot
Posted By: dasbogie
Date Posted: May 13, 2011 at 2:38 PM
I mean the rearm wire of the remote starter to pulse the door trigger of the vehicle. You didn't list what brand of remote starter you're using. I've done this in a few cars and worked out just fine. You didn't list what bypass you are using either and sometimes if it is a data type, it will do rap shutdown.
-------------
Advanced
Posted By: tianot
Date Posted: May 13, 2011 at 2:48 PM
ok, im using a compustar cm3000 module and the bypass is idatalink ads-tb...
-------------
tianot
Posted By: dasbogie
Date Posted: May 13, 2011 at 3:01 PM
on the computstar it looks like on connector 5 there is an ORANGE / white wire labeled as rearm output. You have 2 choices on that vehicle. Bulldog lists using the dome supervision wire for door trigger but it lists it as in the rear quarter of the vehicle at the rim module. You could also run a wire into the door to the driver door module and catch the driver door trigger there. Either way it is - polarity and your rearm output just happens to be - as well. I know going into the door in a cts is actually not too bad. I never did an srx so I cannot vouch but those vehicles are similiar.
-------------
Advanced
Posted By: tianot
Date Posted: May 13, 2011 at 3:42 PM
thanks dude. i keep you updated if it fix the problem. thanks
-------------
tianot
Posted By: ac0j
Date Posted: May 13, 2011 at 9:14 PM
Use any programmable output, or rearm wire to "pulse after" on a door pin wire.
|