I have a 97 GMC 1 ton 4 door crew cab pickup. I'm trying to install Bulldog's 6002 alarm system, and I cannot seem to find the door trigger wires. Does anyone know if they are up under the dash, or in the kick panel as I was told by a mechanic?
I am also searching for a lt blue and white wire for the lock/unlock. I cannot find a lt blue or a white that respond to my DMM when lock/unlock is pressed.
This is just about to get the best of me.
James Ayers
It is positive trigger and the wires are located in the kick panel in the wire harness going into the door, or at the large black plug in the kick.
-------------
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
And I'm pretty sure domelight is purple, at the headlight switch. Or you could probably use the white wire at the underdash courtesy light.
Constant 12 volts RED (2) IGNITION SWITCH HARNESS
Ignition 12 volts PINK IGNITION SWITCH HARNESS
Starter YELLOW IGNITION SWITCH HARNESS
Dome Light PURPLE (-) 4 PIN BLACK CONN. IN DR. KICK PANEL *
Trunk Pin Switch N/A
Parking Lamp BROWN (+) AT HEADLIGHT SWITCH
Power Lock L BLUE DRIVER KICK #203
Power Unlock WHITE PANEL ** #202
* PURPLE (-) Wire Also Located At Headlight Switch. WHITE (-) Wire At Courtesy Light Can Also Be Used But Will Not Trigger Alarm If Dome Lamp Override Switch Is Turned On. ** Without OEM Keyless Entry See Note #203. With OEM Keyless See Note #202. #203- See Reversal Rest At Ground Door Lock Diagram. #202- See Positive Pulse Door Lock Diagram
-------------
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt