cm5000 and rps unlock issue

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=127186
Printed Date: May 16, 2025 at 1:14 AM

Topic: cm5000 and rps unlock issue

Posted By: MrE2u
Subject: cm5000 and rps unlock issue
Date Posted: May 01, 2011 at 7:50 PM

Hi there.

I have a cm5000 installed in my 2004 neon. Alarm works great, remote start works great. The only thing I cannot get going is the lock/unlock via rps sensor.

Following the procedure in the manual I tap 10 times on the rps but I never get the rapid blue flashing I am supposed to.

Any ideas?

thanx

Replies:

Posted By: enice
Date Posted: May 02, 2011 at 6:49 PM

You have to have the ignition on and a door open when progamming the RPS Sensor. Now, Even though you may have your door open you must make sure that the green wire(ign wire) has 12 volts and the RED / white(door trigger) wire from the CM5000 has ground when doing this. If you used your dome light for the trigger then make sure its on.

Posted By: MrE2u
Date Posted: May 02, 2011 at 7:14 PM

enice] wrote:

You have to have the ignition on and a door open when progamming the RPS Sensor. Now, Even though you may have your door open you must make sure that the green wire(ign wire) has 12 volts and the RED / white(door trigger) wire from the CM5000 has ground when doing this. If you used your dome light for the trigger then make sure its on.

Yes, this is the procedure in the manual but I have done this and stilll nothing.

Print Page | Close Window